|
|
|
|
|
|
Tip for the maintenance of spiral classifier
|
|
The spiral classifier machine can be installed after inspection without damage or loose screws. The classifier should be firmly installed on the basis of the poured concrete. The basic design should have a good supporting effect and minimize the shear force on the screws.
How to do the maintenance of spiral classifier
All lubrication points are lubricated with sodium-based grease or calcium-based grease. Each shift should check whether the lubricating oil inside the reducer is on the marking line of the oil needle, and change the oil every 6 months. Always check the lower support or intermediate frame bearings, bearings, sealing rings for wear and damage to the bearings for timely replacement. Bearing lubrication must be filled with high pressure oil into the bearing with a manual dry oil pump every 4 hours to maintain the sealing performance of the bearing.
More tips for operating classifier
https://www.lzzgmachine.com/service-parts/product-knowledge/installation-and-maintenance-of-spiral-classifier.html
|
|
|
|
|
|
|
|
|
|
